Method for assembling sliding bearing

Update:2017-07-18

   (1) the first to remove the sliding bearing assembly for sealing the protective rust agent (closed bearing installation, except) can use hydraulic method of bearing inner ring applied no impact loads will be fitted to the shaft bearing qualified bearing block, if there are no conditions can also use Pratia gently on bearing the inner ring is mounted, ordinary bearings allow color thermal sleeve method, but the heating temperature not exceeding 100 degrees, and the bearing should be relatively uniform for heating.
   (2) the sliding bearing assembly and bearing must be on the same plane, the same line, the same axis, the bearing must be parallel mutually in the same plane parallel to each other, and the corrected assembly gap, the parallelism and beat meets the design requirements, ensure the smooth sliding equipment.http://www.bhsbearings.com/